Malaysia

#Readystock
#Readystock
#Readystock

The Smok RPM is the real Mod Pod Kit by Smoktech, at the same time, they released the RBA core for the Mod Pod Kit, which will help you find your individual vaping style, the screwdriver included to make it easy to convenient to rebuild the pre-built coils. let’s check how to build the Smok RPM RBA today. 

How To Build The RBA?

1.Make sure your hands are clean.
2.Take RBA Deck apart.
3. Installing and positioning the pre-built coil, place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is not touching the base.
4. Cutting the end of wire off.
5. Cutting a strip of cotton and make sure it’s not too much and not too less.
6. Inserting the cotton and placing it in the middle.
7. Cutting the cotton at an angle and make sure it’s not too short and not too long.

Wet the coil with your e-liquid and adjust the cotton.

Note: the resistance of the pre-built coil must be checked before install on the RBA deck, and re-checked periodically to ensure the resistance remains the same. the Smok RPM 40 RBA only supports the resistance of coils over 0.25ohm.

Parameters
Quantity: 1pcs/pack
Coil: 0.6ohm

It comes with
1 x SMOK RPM RBA Coil
1 x Screwdriver
1 x Replacement Screw
3 x Sealing Ring

***************************************************************************************

Parameters
Quantity: 1pcs/pack
Coil: 0.6ohm

How To Build The Rgc RBA?

1.Make sure your hands are clean.
2.Take Rba deck apart.
3.Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is Not touching the base.
4.Cut the ends of wire off.
5.Install the 510 adapter on the RBA deck and activate the device to test the coil. If the coil is not heated evenly from the center outwards , adjustments are required.
6.Cut a strip of cotton and make sure it's not too much and not too less.
7.Insert the cotton, and place it in the middle.
8.Cut the cotton at an angle and make sure it's not too short and not too long.
9.Wet the coil with your liquid and adjust the cotton.

Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.

SMOK RGC RBA Coil Contents:
1 x RPM80 RCG RBA Coil
1 x Screwdriver
4 x Replacement Screw
4 x Sealing Ring