Malaysia

Volume

Lubricant Type

STONE CHIP AND UNDER-BODY PROTECTION BLACK 
Solvent-based coating mass on an rubber basis for painting over.
Suitable for: For touching up and re-establishing original structure and as protection against gravel throw and corrosion in all visible spot such as the front and rear apron, side skirts, bumpers and champs of pas winger car, trucks and buses. 
Also excellently suited as an anti-drumming ms for wheel housings and chassis.Features: The product hay very good adhesive properties and is scratch proof. 
Can be painted over after about 60-90 min. With many standard solvent-based and water-based 1-component and 2- component points. 
No running on vertical spots Suitable for oven drying at 40 to 60 C. 

Application: Shake before use. The surface must be dean, dry e, dust and grease-free. 
Where thicker layer thicknesses are idled e recommend allowing the intermediate layers to flash off. 
Working pressure approx. 3-6 bar. 
The optimum spraying distance s 30 a le ayng results are achieved at a processing temperature of 15-25 C.
Note: Do not spray on joints, engines, gearboxes and brake system.

石屑和车身下保护黑色溶剂基涂层，以橡胶为基础，用于涂漆。

适用于：修补和重建原始结构，并在所有可见点（如pas winger轿车的前裙板和后裙板、侧裙板、保险杠和车座）防止抛石和腐蚀，卡车和公共汽车。也非常适合作为轮罩和底盘的防鼓材料。

特点：该产品具有很好的粘合性能和防刮擦性。约60-90分钟后可涂满。有许多标准溶剂型和水基单组分和双组分点。不可在适合于40至60℃烘箱干燥的垂直点上运行。使用方法：使用前摇匀。表面必须干净、干燥、无灰尘和油脂。如果较厚的层厚度闲置，建议允许中间层闪光。
工作压力约为3-6巴。在15-25℃的加工温度下，可获得最佳的喷涂距离S30。

注意：不要在接头、发动机、变速箱和制动系统上喷涂。


感谢您访问我们的产品！！ 😇
👍如果您对我们的产品和服务感到满意，请给我们留下5⭐⭐⭐⭐⭐评论。
👍在留下不良评论之前，请与我们联系。我们在这里为您提供帮助！

𝐅𝐄𝐄𝐃𝐁𝐀𝐂𝐊 :
🔰  To help us to do better, your feedback & rating is very important to us.
🔰  Please do leave us 5 Star rating if you are satisfied with our product(s) or service(s).
🔰  However, if there are any issues, concerns or whatsoever, please 𝐋𝐈𝐕𝐄 𝐂𝐇𝐀𝐓 us 𝐍𝐎𝐖 before leaving any comment.
🔰  We will try our best to resolve any of your issue(s) that will bring a smile on your face.