Malaysia

This headphone cover is made of high-quality leather + high-quality thick sponge, which is soft and fit, comfortable to wear, durable, easy to clean and easy to take care of (such as dust and sweat, wipe it off with a wet towel)

Suitable models:

Audio-Technica: ATH-MSR7, ATH-SX1, ATH-SX1a, ATH-PRO5, ATH-PRO5V, ATH-M10, ATH-M20, ATH-M30, ATH-M35, ATH-M40FS, ATH-M45, ATH-M50 , ATH-M50S, ATH-M50cwh, ATH-M50X, ATH-M40X, ATH-M30X, ATH-M20X

Disassembly introduction: There is a gap on the side of the original earphone cover. Use a little force to open it along the gap. Please be assured that it will not damage the earphones. You can tear off the old ear cotton. After removing it, clean it up, set the newly purchased earmuffs to the card position, and put them in the gap along the gap a little bit, and then it is stuck on the headset, adjust it again, and arrange it OK

The store’s physical shooting, what you see is what you get:

Headphone head beam protective cover

Size: Length about 22.5CM, width about 8.5CM

This product is made of high-elastic neoprene material, zipper closure, simple and practical, without disassembling the original headphone beam, put it on directly, with customized zipper, dustproof and waterproof, protect your headphone beam from wear

Installation shots of other brand headphones (skull HESH):Add shadow character.有库存，请放心购买