Sell Titebond Ultimate Wood Glue best price

(note) Too good plastic bottle mouth design during delivery may spill gum problems, after standing upright, before reverting to the original. Identification of new production labels A: us production/19: 2019/10: 10/07: 7/173: three yards later This is a sign that each batch of labels will vary according to time Name: waterproof woodworking glue too good glue III Brand: Titebond too good Capacity: 473ml Applicable: woodworking (suitable for wood with high oil content such as teak) Semi-dry: 10 minutes Completely dry: about 1 day (depending on climate) Storage: sealed without contact with air, room temperature should not be too high, kept in the dark, can be put for more than 2 years Characteristics: .Waterproof glue strong force .Usable for food feeders .Non-dry and oily wood available .Non-toxic, with no organic solvents Too good II/too good III comparison: Drying time: too good II > too good III Price: too good II < too good III Waterproof: too good II < too good III Glue strength: too stick II < too stick III Viscosity: too stick II < too stick III Too good glue II box can only hold 9 cans, purchase other items please order!!!! Too good glue III box can only hold 9 cans, purchase other items please order!!!! Description of use: Tai bat III - waterproof woodworking glue, the third-generation latex developed successfully for the bonding of oily and wet wood, was the first single-liquid latex to be tested through ANSI/HPVA first-class water resistance tests. The advantages of too much III are as follows: - Excellent water-resistance, tested by ANSI/HPVA stringent first-class water-resistance test specifications. - Super strong adhesive strength, suitable for oily wood, such as teak, rosewood glue. - Can be cemented at low temperature, no more heating procedures are required. - Solvent resistance, heat resistance and mildew change. - Do not pollute the surface, and the glue can be cleaned in cold water before drying, sand light is not easy to soften. - The product is nontoxic and contains no organic solvents and can be safely exposed to food by binding food containers with FDA certification. Ps: the difference between ansi/HPVA first-class and second-class water-resistant test specifications: Both experiments were made of three plywood made of 6 "x 6" - size birch thin slices. (1) The first-class water resistance test method is to cut the 6 "X6" plywood into a sample of 1 "X3" size and then boil it for 4 hours and remove it for 63°C. dry the oven for 20 hours, then boil it for another 4 hours, then place it in the stream until room temperature, and test the shears immediately before the test sample is dry. (2) The secondary water-resistant test method is to cut the 6 "X6" plywood into a sample of 2 "X5" size and impregnate it for 4 hours before taking it out for 49.°C. 19-hour drying in the oven.After three times of re-leaching, the colloidal layer of the specimen will crack so that it can pass the test standard of secondary water resista