Sell Radiolink R6FG Receiver 2.4GHz 6CH FHSS with Gyro 4.8-10V RC6GS RC4GS RC4G RC3S best price

How to Match Code With Transmitter: 1. Put the transmitter and the receiver close to each other within 50 centimeters. 2. Turn on the transmitter, then power on the R6FG. 3. There is a black button on the R6FG, press the binding button twice in two seconds and release, receiver light start blinking, after about blinking 8 times, match code success then receiver signal LED always on! Attention: R6FG default have not turn on the gyro function. Make sure the R6FG keep motionless when power on it, because the R6FG will do the self-test. R6FG with two indicate LED, green LED on indicate normal working mode while both green and red LED on indicate gyro function working mode. Working Mode R6FG has two working modes：normal working mode and gyro function working mode. Normal Working Mode -- Green LED, gyro will not working. Gyro Function Working Mode -- Both green and red LED on. Receiver with gyro integrated to hold the vehicle in a straight line during aggressive acceleration and braking or get bumped around by rough terrain. Receiver with gyro integrated to keep the uni-direction and anti-slip. How to Turn On Gyro Function : Quick press the ID SET switch two times within 1 second, the LED change from green to red means gyro function has turn on. Setup 1. Enable gyro Press binding key three time (interval less than 1 second), the red LED will flash three time, indicating whether gyro is enabled. 2. Gyro sensitivity Gyro sensitivity is predefined to adjust by channel three (factory set VR function), turning the VR switch clockwise to raise sensitivity and anti-clockwise to decrease. 3. Gyro forward When the gyro is enabled, pull the throttle trigger and then release (make sure the car stops running), turn the car right or left without changing steering wheel, if the servo will not follow with, it shows gyro is set backward. Press the binding switch one time less than 1 second, the LED flashes red once, gyro is changed to act forward. 4. Gyro reverse Set the gyro forward, turn the car right or left to see whether gyro functions. The wheel will turn left when the car is turned right and the wheel turns right when the car is turned left. If the gyro acts counter, press the binding switch two time, the LED flashes two time red, the gyro reverse is corrected. Technical Parameters 1)Frequency: 2.4GHz ISM band(2400MHz~2483.5MHz) 2)Size: 35*20*13mm 3)Channel: 6 4)Model: cars/boats 5)Modulation mode: GFSK 6)Spread spectrum: FHSS 7)10 modes memory storage 8)Antenna length: 200mm 9)Control distance: more than 400 meters 10)LCD screen: 128*64 resolution, LCD back light 11)Power supply: 4.8~10.0V DC 12)RF power: <10dbm 13)Channel resolution: 4096 14)Work current: 30mA 15)Compatible with transmitters: RC6GS, RC4GS, RC4G, RC3S, T8FB