Sell Pentens Seal Self-adhesive Rubberized Asphalt 50mm best price
4.7
6
ratings
5
sold
MYR 25.5
30% OFF
MYR 17.85
Brand | PENTENS |
---|---|
Ships from | Selangor |
Product Description
[READY STOCK] Pentens Seal Self-adhesive Rubberized Asphalt
Specification:
Form: Plastic composite section
Flash Point: Over 65°C
Solid Content: 100%
Color: Silver, black underside
Application Temperature: 5°C to 50°C
Toxicity: Non-toxic
Staining: PENTENS SEAL will not stain porous materials outside its area of application but care is necessary during the application of the bitumen-based surface conditioner
UV Resistance: Good resistance against UV light and other weathering agents
Storage: Store in a dry, cool place
Shelf Life: 12 months in original containers
Packaging: 50mm x 10 meter /roll
Description:
● PENTENS SEAL is a flexible polymer-modified bituminous strip with a matt grey vinyl-coated aluminum foil facing. It is a flexible waterproofing seal in all conditions of exposure.
● PENTENS SEAL should not be used on unprotected traffic surfaces as they may be susceptible to damage, except for roof areas that are subject to occasional maintenance access only.
Uses:
PENTENS SEAL is a general purpose sealing and flashing strip for weather resistance and waterproofing
that is widely used in building construction and maintenance work. Available in a range of roll width
from 50 mm to 300 mm. PENTENS SEAL consists of a self-adhesive polymer-modified bitumen strip face
with a matt grey vinyl finish aluminum foil. It adheres permanently to most building substrates and is easy to
handle and shaped as required on site. It is best used under these circumstances:
● Roof work, capping, guttering, sheet laps, vertical DPC for opening in brick and block work
● Flashings to fascia panels
● Protection to steel work
● Rear air seal to drained joint systems
● Airtight dust seal to concealed panel joints
Advantages:
■ Provides a durable weatherproof seal.
■ Adheres instantly to most prepared surfaces.
■ Easy to form and apply.
■ Does not creep or sag in vertical applications
Instruction for Use
Application
Exceptionally rough surfaces may require the application of a bead of PENTENS 607 to provide sufficient gap filling prior to the application of PENTENS SEAL.
PENTENS SEAL can be easily cut to convenient lengths or shaped with a sharp knife. Once the backing paper has been removed, PENTENS SEAL must have a side overlap of a minimum of 10mm and the end overlap 25mm.
PENTENS SEAL can be dressed into different angles and curves. However, care must be taken to avoid puncturing the material with sharp objects or damage from foot traffic.