Sell opening promotion●▪Hobbywing XRotor Micro 60A 4in1 ESC & FC F7 best price

Make your electronics stack work for you, not the other way around. FEATURES - Convertible F7 FC - Super hardware and running speed - Special interface for DJI image transmission system - On-board 5V & 12V dual BEC circuit - On-board Pit Switch module - Perfectly support firmware of various FPV - Unique installation design and shock absorption structure - Perfectly match with Hobbywing ESC -60A 4-in-1 ESC- - High-performance 32-bit microprocessor with the running frequency of up to 48MHz for an excellent performance. - BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S. - All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling. - Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up. - Onboard 10V &5V BEC, powering different accessories such as FC, VTX, Camera and LED lights and etc. SPECIFICATIONS - Convertible F7 FC Firmware: HOBBYWING_XROTORF7CONV FC Programming: Supported Programming via: Betaflight/Cleanflight-configurator Compatible with (Modes): PWM、Oneshot125、Oneshot42、Multishot、Dshot150、Dshot300、Dshot600、PROSHOT1000 Compatible with (Transmitters): PPM、Spektrum、SBUS、SUMD、SUMH、 XBUS、IBUS、JETIEXBUS、CRSF、SRXL OSD: Built-in BEC: 5V @ 1.5A ; 10V @ 1.5A Voltage Monitoring: Supported Current Monitoring: Supported External Buzzer: Supported LED Control: Supported USB Port: MicroUSB Size: 32x32mm Weight: 3.3g -60A 4-in-1 ESC- LiPo Power input: 3S-6S Cont.Current: 60Ax4 Burst Current: 80Ax4 BEC Output: 5V@ 0.5A Input wires: 12AWG-130mm* (Red/Black) Output Wire: No wires but solder tabs Connectors: (In/Out) XT60 (w/ Wires Soldered on) /no Weight / Size: 15.0g / 32.7x18.4x6.2mm Mounting holes: 30.5x30.5mm Throttle Calibration: Supported ESC Programming: BLHeliSuite32