Sell keshieng 110V Desoldering Suction Pump Handheld Electric Tin Suction Sucker Pen best price
5
2
ratings
2
sold
MYR 19.65
1% OFF
MYR 19.46
Ships from | Mainland China |
---|---|
Variation | H02 |
Product Description
Keshieng Desoldering Suction Pump Handheld Electric Tin Suction Sucker Pen
description:
feature:
842A
The electric dual-purpose tin suction cup is beautiful and convenient
Suction tin. Can be used to remove components from the circuit board
At the same time, the components and the circuit board are not damaged. especially
Used to replace integrated circuits and multi-pin switches.
The tin suction cup can be used as a general electric iron. it's a
Basic tools for national defense, scientific research, communication,
Aerospace, Computer, Radio, Television, Electronics Major
Maintenance personnel and most radio enthusiasts.
Description:
1. Use 110V power supply, power 30W;
2. Turn on the power and warm up for 3-5 minutes;
3.
Press the piston handle and align the tin nozzle
Soldering part; after the tin is melted, press the control button,
The solder is sucked into the cylinder;
4. The tin suction device is equipped with two suction nozzles with different diameters according to the thickness of the component leads;
5. When soldering, the operation is the same as the soldering iron;
6.
When disassembling the cylinder, please press down the top of the cylinder
According to the direction of the arrow, pull the cylinder and
Separate treatment at the same time, can separate the cylinder;
When removing the nozzle, rotate it counterclockwise, then
Remove it;
notes:
1. Check whether the voltage is consistent, too high or too low voltage is not conducive to use;
2. Before use, rotate the cylinder and nozzle to prevent leakage. Otherwise it will affect the suction.
3. Frequently remove solder impurities from the suction nozzle and cylinder, and add a little oil to the piston;
4. After each use, push the piston 3-4 times to remove the remaining straw on the straw, so that the straw can be used smoothly next time.
5. It is strictly forbidden to install and remove a part of its electrical components while the tin suction device is energized.
6.
Under normal circumstances, the first heating will produce a small amount of smoke
It's time to use a new suction pump. It will disappear naturally
10 minutes.
7. When using, it must be equipped with a naturally cooled soldering iron base, and the suction pen should be placed in the soldering iron base.
8.
If the power cord is damaged, to avoid danger, it must be replaced with
Manufacturer or maintenance department or similar full-time personnel
personnel.
9. The ground wire of this product should be used with a socket with contacts. Please be careful.
note:
2. Since it is a manual measurement, please allow
The error is 1-3cm. Make sure you do n’t mind bidding.
3. Different due to different
When displayed, the image may not reflect the actual color of the item.
After receiving the payment, we will leave positive feedback. We will highly appreciate your positive feedback on 5 stars!