Sell iTogether Soap Dispensers No-Drill Wall Mount Shampoo Shower Dispensers Spray paint Hand Soap Dispenser for Bathroom Kitchen best price

Are you worried about a variety of dispersed liquid care products? iTogehter double hole soap dispenser can solve your troubles. It can be installed in bathrooms, kitchens, sinks, laundry rooms and other places. It can help you arrange and distribute various liquid products. Make your life easier. 【product manual】 ♥ Material: ABS material, more environmentally friendly and safe, has strong impact resistance, scratch resistance, dimensional stability and other characteristics, and has moisture resistance and corrosion resistance. ♥ Design: Combined design, push the bottle up, you can remove it for easy adding and cleaning 【Product Features】 Length: 12 cm * 5 cm * 19.8 cm (Double) 6 cm * 5 cm * 19.8 cm (Single) 【Capacity】 1-chamber：250ml 2-chamber：500ml （250ml X 2 ） 3-chamber：750ml （250ml X 3 ） 📢“1-chamber” is 250ml; 500ml is composed of two "1-chamber", 750ml is composed of three "1-chamber" 📢Different numbers of chambers have different bases and cannot be separated (“2-chamber” cannot be split into two “1-chambers”, if separated, There will be one that doesn't have a base to use) *If there is residual water in the bottle or pump . Please don't worry. This is normal. (each product must be tested with water before leaving the factory.) 【Color】 White / Black +Sliver（plating） 【Product Composition】 Soap dispenser X 1 Screw mounting kit X 1 Special tape X 4 glue X 1 【NO-Drill installation steps】 ①. Select and clean locations ② .Stick the tape evenly on the base plate or the back of the product ③.Apply glue to the rest of the base and make the glue thicker than the tape ④. Align the product of the selected position, and press the product position with pressure to squeeze out excess air to prevent air bubbles ⑤.After waiting for 12 hours, combine the bottle and base to complete the installation * Note: Please use all the tape and glue as much as possible to make it stronger 【Drilling installation method】 ① Remove the soap dispenser base, and mark the screw position on the wall according to the base to keep it level. ② Drill holes at the marked locations, and then insert the plastic bolt holder into the wall. ③ Pass the screw through the hole of the base, align it with the drilling position, insert the screw into the hole of the base, and then tighten the screw to fix the base ④ After mounting the base on the wall, combine the bottle body with the base 💡【Q&A】💡 (1)：What kind of liquid is suitable for adding? -This product adopts manual pressing methods It is not recommended to add high-viscosity liquid products (such as paste、cream)。 If you need to add a high-viscosity liquid, be sure to dilute it with water (2)：Can't squeeze out liquid? -Normal ! The first use requires multiple presses to remove internal air. As the number of uses increases, it becomes smoother (3):If there is residual water in the bottle or pump . Please don't worry. This is normal. (each product must be tested with water before leaving the factory.)