Sell Holybro Kakute F4 V2 Mini STM32 F405 Flight Controller Control With Betaflight and Cleanflight OSD Board for FPV Freestyle Drone best price

The Holybro Kakute F4 V2mini flight controller supports important features of Betaflight / Cleanflight, such as OSD and Dshot. The faster F4 processor gives room for future feature development: all functions run at the fast 8 kHz PID loop rate, with a single-digit CPU load! Due to problems with serial inversion, other F4 boards are struggling to support protocols like FrSky SBUS and SmartPort at the same time. The Kakute F4 V2mini is designed to support all serial protocols at once. Features • Supports Betaflight and Cleanflight. • Betaflight OSD. Change PIDs, set common configuration parameters, and change video transmitter channel and power level, all with your transmitter sticks and glasses. • High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer. • Ready for autonomous flight: integrated BMP280 barometer and SCL / SDA for use with external GPS / magnetometer units. • Dedicated bootloader button for easy firmware flashing. • Low-profile design also fits into very compact frames. • Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B +” pad only). • Automatic voltage monitoring. No need to use a separate vBat wire for voltage monitoring; The Kakute F4 V2mini monitors voltage directly from the battery power lead. • On-board controller output 5v with up to 1.0 amps and 3.3v up to 200 mA to power peripheral devices such as receivers, video transmitters, FPV cameras, or LED strips. • Supports BLHeli pass-through for easy ESC upgrade and configuration. • 2 additional PWM outputs, can be used for camera control, motor5 or motor6 according to means. Specifications • MCU: STM32F405RGT6 32-bit processor • IMU: MPU6000 (SPI) • Barometer: BMP280 • USB VCP driver (all UARTs can be used at the same time; USB does not take a UART) • 5 hardware UARTS (UART1,3,4, 5, 6) • Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported. • 128 Mbit data flash chip for black box logging • Dimensions: 32x29x6mm (includes USB in height) • Mounting holes: Standard 20mm square to the center of the holes • Weight: 4.4g Package Contains: 1 x FC board 4 x M3 anti-vibration silicone insert grommet 1 x JST SH 8pin 150mm cable 1 x JST SH 6pin 150mm cable (The cable that goes to the CADDX Vista Air Unit is included.) 1 x JST SH 6pin to GH 8pin 150mm cable (The cable that goes to the DJI Air unit is included.) 1 x JST SH 6pin to GH 8pin 80mm cable (The cable that goes to the DJI Air unit is included.)