Sell AIYIMA DAC-A2 Headphone Amplifier DAC with Bass Treble Controls PC-USB/Optical/Coaxial Inputs, RCA/3.5mm Headphone Ouput Digital to Analog Desktop Audio Converter 5V 24Bit 192kHz best price

Specifications: PC-USB supports input sampling rate: 96K/24Bit High and low sound adjustment range: ±6dB Fiber/coaxial support input sampling rate: 192K/24Bit Frequency response: 20Hz-20kHz (±3dB) PC-USB support operating system: XP/W7/W8/W10/MAC/linux Distortion: 0.01% Amp output maximum power: 100mW 32Ω load Signal to noise ratio: ≥105dB Headphone matching impedance: 16-200Ω Working voltage: DC5V RCA output level: 2.3V Size (L*W*H): 73.5*98*33MM (without knobs and terminals) PC-USB operating instructions: 1. Connect the PC-USB interface on the rear panel of the machine with the factory-configured USB cable (USB can support hot plugging) 2. Press the input signal selection button to select the USB input. 3. Find the icon with the horn symbol in the lower right corner of the PC 4. Click the right button to pop up the dialog box and click "Select Play Player" 5. Pop-up dialog box to select the playback device recognized by the PC (this machine USB is automatically recognized, free to install the driver manually) 6. Click to confirm the recognized digital output. Operation Steps: 1. Connect the rear-end device that needs an external connection to the audio output connector. 2. Connect the audio source you want to use to the audio input connector. 3. Connect the power supply. 4. Turn the volume knob clockwise to turn it on and select the desired volume level. 5. Select the desired EQ by rotating the bass treble knob. 6. When the amp output is connected, the RCA analog output will be automatically disconnected. Common problem: Q: All the lines are connected, but there is no sound output? Answer: 1. Check if the POWER indicator is on. After the power button is pressed, the indicator still does not light. At this time, you can find an equivalent voltage output (must be 5V) in the test to judge the machine failure or power failure. If the POWER indicator is on, check if the corresponding input signal is selected correctly. 2. If the above two points are checked or no sound, check if the VOL knob is in the minimum state, such as clockwise rotation in the minimum state; 3. If both of the above are normal, check if the playback device of the input source is paused, muted, or the volume is at its minimum. Q: Why is the sound broken? A: Although this product is a DAC decoder, it can also be used as a pre-stage product. It has amplifying effect. If the volume of the rear-end device is adjusted to the maximum and the pre-stage is also adjusted to the maximum, it is easy to be distorted. You only need to turn down the volume of the front or back level. Q: Why does the speaker have a large current sound? A: If you are not using the original standard power supply, please replace the power supply before testing. A lot of power supply in the market has a large interference coefficient, which will cause a large current sound. Package included: 1Pcs Amplifier(without supply power)