Sell Adjustable Timer (Relay) up-to 5A DC/AC w/ Trigger & Delay & Micro USB Power best price

Features Wide working input voltage from DC 5 to 36V, widely used in many device Interface are clear and simple, and meet all your needs Emergency "STOP" button Reverse polarity protection, reverse polarity will not burn this module board Sleep Mode - if this mode is enabled, screen will automatically turn off if without any operation for 5 minutes, any key will wake it up Settable OP, CL, LOP, which are independent of each other and are automatically saved After the module is powered down, all settings are memorized and will not lost Optocoupler isolation, enhanced anti-jamming capability, industrial grade board Specifications Power Supply: 6 - 30V DC / Micro USB 5.0V DC Trigger Source: Active-high (3.0 - 24V) Output capability: DC 30VDC 5A or 220VAC 5A device Standby Current: 20mA Operating Current: 50mA Life span: more than 10 million times Working temperature: -40 to +85 ℃ Size: 6.2 * 3.8 * 1.7cm Mode P1: (Require an external trigger signal) After trigger signal received, turn on the LOAD for OP time then turn off the LOAD and waiting for next signal to on again. Below are the options while OP is operating: P1.1: Signal being trigger again will not interrupt the OP P1.2: Signal being trigger again start OP again P1.3: Signal being trigger again reset the timer and waiting for trigger signal again; (Turn off the LOAD & stop timing) P2: (Require an external trigger signal) After trigger signal received, turn off the LOAD for CL time then turn on the LOAD for OP time and waiting for next signal to off again. P3.1: (Require an external trigger signal) After trigger signal received, turn on the LOAD for OP time then turn off the LOAD for CL time, this will continuous loop / cycle. Once trigger signal received again LOAD will off and loop will stop. Cycle times (LOP) can be pre-set. P3.2: (No trigger signal require) Autorun, turn on the LOAD for OP time then turn off the LOAD for CL time, this will continuous loop / cycle. Cycle times (LOP) can be pre-set. P4: (Require an external trigger signal) After trigger signal received, turn on the LOAD then start time counter Once no more trigger signal LOAD will off and counter will stop. p.s “LOAD” is the device you are going to control to on / off Time 0.1 second (minimum) ~ 999 minute (maximum) adjustable Press STOP button to select the time frame by adjusting the decimal point xxx. – Decimal point at the back, 1 – 999 second xx.x – Decimal point at middle, 0.1 – 99.9 second x.x.x – Decimal point all light up, 1 – 999 minute How to set The blinking Mode ​at the main menu is current mode (default is P1.1) To select the Mode by press and hold SET key for 2 seconds and select interface mode by pressing UP / DOWN key to choose the Mode (P1.1 ~ P4) and press SET to confirm After confirm the mode, it will need to set OP Time ​– Power on time (Closed circuit), UP / DOWN ​to choose, SET to confirm